For most fabrics, hoop marks can be removed or significantly reduced after embroidery - act quickly for the best results.

• Dampen the affected area with a clean cloth and a little water, then gently steam with an iron held just above the fabric - don't press directly onto the embroidery
• For stubborn marks, a shot of steam directed onto the back of the fabric can help lift the fibres back up
• Always check the fabric care instructions before applying heat or moisture
• The longer hoop marks are left, the harder they are to remove - treat them as soon as the embroidery is finished for the best chance of success

Over-tightening is the most common cause of hoop marks. The fabric needs to be taut but the hoop doesn't need to be as tight as possible.

• Snug and firm is enough - the fabric should feel taut like a drum without forcing the hoop screw to its limit
• If you find yourself needing to over-tighten to keep the fabric stable, the stabiliser choice may need reviewing

Magnetic hoops hold the fabric between two magnetic frames rather than clamping it, which eliminates the pressure that causes hoop marks altogether.

• They're particularly useful for delicate fabrics, velvet, fleece and anything that marks easily
• If you're regularly working with fabrics that are prone to hoop marks, a magnetic hoop is well worth the investment

Wrapping the inner hoop ring with twill tape or soft fabric strips provides a gentler, more even grip that's much less likely to leave marks.

• Wind twill tape or a thin strip of fabric around the inner ring and secure the end firmly before hooping
• Some embroiderers also place a piece of thin foam or felt between the hoop and the fabric for extra protection on delicate materials

Rather than hooping the fabric directly, an adhesive stabiliser can be hooped on its own and the fabric adhered to it - keeping the fabric stable during embroidery without the hoop ever touching it.

• Madeira Cotton Fix and Filmoplast are both self-adhesive stabilisers well suited to this approach
• Hoop the stabiliser, score and peel back the protective layer, then position the fabric on the adhesive surface
• This eliminates the risk of hoop marks entirely and is particularly useful for velvet, delicate knits and anything that would be damaged by direct hooping

Before embroidering on your actual piece, test your hooping method on a scrap of the same fabric. Check for any marking after removing from the hoop and adjust your approach before committing to the real thing.